Cover for article.
React Native/Expo with VirtualBox and Genymotion
3rd September, 2018
3 min read / 485 words

My home PC runs Windows for various conveniences, such as gaming. However, for development, I run an Ubuntu virtual machine (VM) and Genymotion (on Windows) for testing my app. Genymotion also uses VirtualBox to run its Android emulators. So we work out how to let two VMs running on the same host communicate with each other (Ubuntu and Android Emulator).

Please Note: This will also work for VMWare Player.


There are a few networking options we can choose from when setting up a VM.

  • NAT: Allows your VMs so communicate with the outside world (outbound network), but your host machine (Windows)has no way to access this network
  • Bridged: Allows your VMs to access a network using the host computer’s Ethernet adapter. However this adds a bit of complexity, as your VM needs it own identity on the network as essentially its treated like another physical machine.
  • Host-only: Acts a hybrid between the other two options. It allows your VM to communicate with your host machine. So essentially all we need for multiple VMs to communicate with each is other is to turn on Host-only network (on all VMs). This allow them to communicate with the host machine which will act as a “bridge” (no pun intended).

Network Diagaram


  • VirtualBox Installed on the host machine
  • An Expo app in the (Ubuntu) development VM
  • Genymotion Installed and setup on the host machine


  • Open up VirtualBox
  • Click on the development VM and open the “Settings”.
  • Go to “Network” and Set the following two adapters, as shown in Figure 1
  • Adapter 1: “Host-only Adapter”
  • Adapter 2: “NAT”

NAT allows the Ubuntu VM to use the host machines internet access, it allows it to communicate with the outside world. The Host-only Adapter allows the Ubuntu VM to communicate with other VM, such as the Genymotion Android emulator.

Figure 1: Ubuntu VM network settings Figure 1: Ubuntu VM network settings


Genymotion network settings are pretty much the same as the Ubuntu VM, as shown in Figure 2. Please note that the Host-only adapters can be the same (i.e. #7).

Figure 2: Android emulator VM network settings Figure 2: Android emulator VM network settings


  • Start your Genymotion Android emulator.
  • Start your Ubuntu VM and open a terminal.
  • Replace the IP Address with your own one, you can find your IP address on the Android emulator. As shown in Figure 3.
adb connect
exp start
exp android

Figure 3: Genymotion Android emulator’s IP address

That’s it you should see your app running on the Genymotion Android emulator now. You can see how to start the application below in Figure 4.

Figure 4: Starting Expo application on Android emulator


    Table of contents

  • Solution
  • Prerequisites
  • VirtualBox
  • Genymotion
  • Expo
  • Appendix

Similar Posts

Theme your Expo app with Redux and React Navigation

23rd December, 2018

7 min read

Recently whilst developing a React Native app (with Expo), I built a simple tab navigator using…


How to add your own type definitions to DefinitelyTyped

19th April, 2019

9 min read

Recently I started using TypeScript (TS) with React Native. Now I won't be going over the benefits…

© Copyright 2020, Haseeb Majid. All Rights Reserved.
Contact me at